1. A breve aggiorneremo la piattaforma di Reboot per risolvere alcuni problemi con i plug-in, quindi chiediamo ancora un po' di pazienza, Lo staff di Reboot

3DS Help about 2DS Hardmod

Discussione in 'English Forums' iniziata da cyborgg, 19 Mag 2016.

  1. cyborgg

    cyborgg Livello 1

    Iscritto:
    5 Mag 2016
    Messaggi:
    8
    Like ricevuti:
    2
    Hi, I have a problem with a hardmod that I would like to do, because I flash wrong my 2DS with a MSET for 3DS, and then when I reboot settings I the Console demands to turn on the switch 3D but my 2DS doesn't have it, I was looking for a solution and I made the hardmod with to conect with SD some connector but the when I turn on the console appear this errorcode - bootrom 8046 errcode: 00f800fee 00000000 00000000 00000200 00400000 - I didnt know what happend but I upload some pictures about it, I hope that you can help me :grinning:
     

    File Allegati:

    #1
  2. StandardBus

    StandardBus Staff Alan Staff

    Iscritto:
    15 Dic 2014
    Messaggi:
    4.091
    Like ricevuti:
    5.308
    this happens when you connect the 3DS to a PC or also when disconnected?
     
    #2
  3. cyborgg

    cyborgg Livello 1

    Iscritto:
    5 Mag 2016
    Messaggi:
    8
    Like ricevuti:
    2
    This blue screen appear when only turn on the console, no about to connect or disconnect
     
    #3
  4. StandardBus

    StandardBus Staff Alan Staff

    Iscritto:
    15 Dic 2014
    Messaggi:
    4.091
    Like ricevuti:
    5.308
    Please check all solder points, maybe you short circuited something.
    The blue screen should appear only when the 3DS fakeSD is connected to a PC. In any other case isn't a good thing.
     
    #4
  5. cyborgg

    cyborgg Livello 1

    Iscritto:
    5 Mag 2016
    Messaggi:
    8
    Like ricevuti:
    2
    But the motherboard could be live yet?
     
    #5
  6. StandardBus

    StandardBus Staff Alan Staff

    Iscritto:
    15 Dic 2014
    Messaggi:
    4.091
    Like ricevuti:
    5.308
    You have to check all connection twice, or disconnect them, in order to verify what's wrong.
     
    #6
  7. cyborgg

    cyborgg Livello 1

    Iscritto:
    5 Mag 2016
    Messaggi:
    8
    Like ricevuti:
    2
    I remember that the person who make the job of solder wires he told me to clean the solder with contact cleaner o alcohol but if I did do that there would be any problem
     
    #7
  8. StandardBus

    StandardBus Staff Alan Staff

    Iscritto:
    15 Dic 2014
    Messaggi:
    4.091
    Like ricevuti:
    5.308
    just disconnect the wires from the mainboard without cleaning it.
    Just before you desolder the wires, melt some fresh tin all over the soldering stylus tip.
    Remember that it should be shining, and smoke should go up from them.
    If the tip is smoking, this means that the flux inside the tin is doing its job mantaining active the stylus tip.
     
    #8
Sto caricando...

Condividi questa Pagina